Brush With Collision

Just a small tip to avoid hairs in your head when using the brush.

brush-collision

Follow up:

This is really simple. In the brush settings you have to check the "Collisions" check-box.
So no need to put a collision tag on your head.
Un-checking the "Visible Only" check-box makes the work easier too.

brush-collision-tut
2006-01-30 — Hair — 3 feedbacks » — PermalinkPermalink

3 comments

Comment from: Gordon Stewart [Visitor]
Is there a trick to this, because I am still able to brush the hair guides underneath the mesh. I have collision turned on with a radius of 0.1, but I'm constantly brushing my hairs right through the surface. Even with a collider tag on the object.
2006-05-03 @ 22:09
Comment from: base80 [Member] Email
I am probably a lucky guy. I usually stay close to the default and get good results.
And sometimes higher figures are better.
2006-05-03 @ 23:32
Comment from: BerTiN [Visitor]
I have the same problem than Gordon Stewart..
2007-03-05 @ 19:20

Leave a comment


Your email address will not be revealed on this site.

Your URL will be displayed.
PoorExcellent
(Line breaks become <br />)
(Name, email & website)
(Allow users to contact you through a message form (your email will not be revealed.)
This is a captcha-picture. It is used to prevent mass-access by robots.
Please enter the characters from the image above. (case insensitive)